- #Remote mouse laser install
- #Remote mouse laser drivers
- #Remote mouse laser driver
- #Remote mouse laser Pc
- #Remote mouse laser windows
Unplug the projector power cord and wait 15 seconds, then plug the power cord back in. Wait for the projector to finish its cool-down cycle Power the projector lamp down by pressing the power button and then pressing it again to confirm the power down. Unplug the USB cable from the PC/notebook #2 - remote USB not recognized/enumerated #1 - remote USB recognized, but mouse function not workingĮnsure that the remote "hatch" cover is securely closed, allowing the sensing switch to engage. The fix for this situation is to power down the projector and, after it has finished cooling, to unplug it for several seconds, then re-plug and restart the projector.
#Remote mouse laser driver
These driver loads do not happen if the device is not recognized/enumerated.
#Remote mouse laser drivers
If the USB remote functions are recognized and enumerated, the system will load drivers for a USB mouse and a USB keyboard and will add these devices to device manager. In some cases, the hatch may appear closed, but if it not closed tightly, the sensing switch will not sense that the hatch is closed and the mouse cursor control will not work.Ģ) In some cases, the PC/notebook may not recognize or enumerate the remote mouse/keyboard. When the hatch is securely closed, the mouse functions to control the cursor on the PC/notebook. When the hatch is opened, the mouse pad allows the user to navigate through the projector OSD. There are two potential problems you may experience:ġ) The mouse control of the cursor will not work unless the "access hatch" on the remote is fully closed.
#Remote mouse laser Pc
The remote USB mouse function of the 3100MP or 3200MP projector remote control is not recognized or enumerated by the PC or notebook computer or the mouse functions and/or the pg up and pg down functions of the remote do not work. Here is some troubleshooting information: If using the Dell 3100MP or 3200MP projector, the USB cable is part of the main input cable that goes from the projector to the VGA port on the system.įor the 2100MP and 2200MP you can see a picture of the USB cable here.įor the 3100MP and 3200MP you can see a picture of the main imput cable and the USB portion of the cable here. The USB cable from the projector to the system as well. You would need to connect your main input cable from the projector to the system, and then connect
If you are using a Dell 2100MP or 2200MP projector, the USB cable will be stand alone. Open and close the door to verify it is closed properly. The remote control will not operate in mouse capability mode if the remote control panel door is open.
#Remote mouse laser windows
Windows 2000 and XP have native support for this.
#Remote mouse laser install
If the USB interface has been installed on the computer, Windows will automatically detect the USB mouse interface and install the appropriate driver. Since USB is a plug and play standard, the USB interface cable can be plugged into the computer after the computer is running. The input cable contains a USB connection for remote mouse access.ġ)In order to set this up correctly, the following must be performed:Ģ)Connect the input signal cable to the computer and the projector.ģ)Power on the projector and allow it to boot.ĥ)Power on the computer and allow for detection of the USB device. A remote mouse cable is provided with the projector. The Remote Mouse capability allows the user to use the remote control to remotely move the computer's mouse cursor. The trigger on the bottom of the remote control acts as the "Enter" or mouse click button when using the remote control for remote mouse capability. The remote control allows the user to perform projector keypad functions, utilize a laser pointer, as well as perform remote mouse capabilites. Thank you for using the Dell Community Forum.įor the "Remote Mouse" feature to work, you have to have the USB cable connected from the system to the projector.
0 kommentar(er)
